Table of Contents
show
How can I ruin my plumbing?
There is truth in the saying that leave it to the professionals if you’re not adept at fixing a particular plumbing issue. Read more about the topics on this wonderful post from Texas Patio Builder.What is wrong with my plumbing?
It’s a basic question to ask if you’re just starting our. Sometimes you’ll encounter issues even if you’ve fixed an issue already. For more information, read this great write-up from Home Climates.
Need Plumbing Help? Use This Great Info!
Welcome to the wide world of plumbing. Plumbing entails a lot more than toilets and sinks, as you will soon find out as you delve deeper into the pipe-laden world. Plumbing is a matter of personal preferences and abilities, so it is not always easy to find what works for you. The ideas and insights in the following paragraphs are going to fill your mind with good ideas. The next time you have a clogged drain, avoid the simple solution of dumping drain-clearing chemicals into the pipes. While this method involves the least amount of effort, the chemicals in these liquid cleaners are destructive to your piping. Instead, consider using a little bit of elbow grease with a plunger, snake, or other device designed to clear your clog without chemicals.
Ideas On Plumbing Repair
To prevent the pipes from freezing, it is advisable to seal off air vents, cracks and access doors. In order to keep the heat in and the cold out, you can try using insulation or caulk. In the event a leak occurs, make it a point to remind everyone where the master circuit breaker is so it can be shut off immediately. To winterize a house that will sit unused during the winter months, you must completely drain all of the pipes. After turning off the main water supply, let all of the water drain from the faucets, toilets, and water heater (turn off the gas). Add a quart of antifreeze to sinks and the tub to prevent water from freezing in the drain trap. Be careful about using liquid clog cleaners. These liquids can contain chemicals that are extremely bad for your pipes. Instead, use a snake or a plunger to dislodge any clogs you might encounter. Be sure to try these things before giving up and calling a plumber, who will probably re-perform those same acts. Check how well your toilets are flushing. If the handle needs to be played with in order to keep the water from running constantly, or if it needs to be held down several times in order to flush, you may need to switch out some of the parts in your tank. This is not expensive, and it could help reduce your monthly water bill. It could also mean that you avoid the embarrassment of the flushing system breaking when you have visitors!
If your water is coming out black, then most likely you have an iron and magnesium issue to your water. You need to contact a water softener company, and get them to come out and assess your water. They will be able to fix the problem by adding a water softener.
Have you tried patching your pipe with the store-bought patching kits only to have that section of your plumbing continue leaking? Replacing the damaged pipe is a more permanent solution than patching. First, you must shut off the main water valve, and drain the water from the damaged section. Cut out the damaged section of the copper pipe, leaving about an inch of extra pipe on both sides of the damaged area. Remove corrosion from inside the pipes with a wire brush. Apply flux to the replacement pipe and the remaining pipe. Slide the piece of replacement pipe into place with couplings. Apply solder all around the joint, and use a propane torch to solder the replacement section into place.
